Kindly Morrow
Automatic Electric Wire Stripper, 400W
Feed wire in, pull stripped ends out. This 400W benchtop stripper handles AWG 36 through AWG 10 at 15 meters per minute, no hand fatigue, no blade swapping, no manual dial between gauges. Built for production volume, not occasional use.
The self-adjusting blade mechanism reads the wire diameter and sets clearance automatically, whether you are running 28 AWG signal wire or 10 AWG power cable. Continuous duty rating means the motor holds 15 m/min through a full batch run without thermal rollback. Fixed benchtop mount with open clearance required on both the feed and output sides.
Things to build with this
- Small-batch harness station: pair this with a pneumatic crimp press and a label printer to run bulk spool straight to labeled, terminated harness segments. The 15 m/min feed rate keeps the stripper from being the bottleneck, so your crimp press determines throughput.
- Sensor loom prep: pre-strip 50 to 100 fine-gauge sensor leads (28 AWG, 30 AWG) to consistent lengths before a connector-crimping session. The auto blade adjustment means you can run 28 AWG signal wire immediately after 18 AWG power leads without stopping to reconfigure.
- CNC or laser machine rewire: strip and stage every replacement wire run before you touch the old harness. With all leads pre-cut and pre-stripped, machine downtime is limited to the actual swap, not the prep work.
Key Features
- 400W motor: continuous duty rated at full 15 m/min feed rate, no thermal throttling on long runs
- Stripping range: AWG 36 to AWG 10 (0.06mm to 4mm conductor diameter)
- Self-adjusting blade mechanism: no manual dial or blade change when switching wire gauges
- Handles both solid and stranded copper wire across the full rated range
- Consistent strip length across high-volume batches, reducing rework and scrap
- Fixed benchtop form factor, requires open clearance on feed and output ends for wire pass-through
- Plug and play operation, no calibration software, drivers, or setup routines required
Frequently Asked Questions
Can it handle fine gauge wire like 28 AWG or 30 AWG without nicking the conductor?
Yes. The rated range starts at AWG 36 (0.06mm), so 28 and 30 AWG are well within spec. Run a test strip when starting a new wire type to confirm blade clearance before committing to a full batch.
Does the blade actually auto-adjust when I switch gauges mid-run, or do I have to stop and reconfigure?
It self-adjusts within the rated AWG 36 to AWG 10 range. No manual dial change required. That said, run a verification strip any time you jump between significantly different gauges. Confirm strip length and insulation clearance before running production volume.
Can I clamp this to a workbench temporarily or use it handheld?
Neither. This is a fixed benchtop machine. Plan for a dedicated surface with open clearance on both the input and output sides for wire pass-through. It is not designed for portable or temporary setups.
What is the strip length, and can I adjust it?
Strip length is adjustable. Set it before your run and the machine holds that length consistently across the batch. Check your specific length setting in the unit controls before starting production.
Why we stock this
Curated by Kindly Morrow. We test and vet every product before it hits the store. If we wouldn't use it in our own builds, we don't sell it.
Things to build with this
Fun projects to try once you get your hands on it.
Connect it to Home Assistant
Most hardware plays nice with Home Assistant. Add it to your dashboard, write an automation, and make your home a little smarter.
Hook it up to Claude
Wire it to an API, point it at Claude, and let AI decide what it does. The future of hardware is firmware you didn't write.
Give it to a kid and watch what happens
Half the fun of hardware is watching someone else figure it out. No instructions, just vibes.
